User's Manual

GE865 Hardware User Guide
1vv0300799 Rev.11 13-07-2010
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 69 of 82
13.3 Recommended foot print for the application
In order to easily rework the GE865 is suggested to consider on the application a 1.5mm
Inhibit area around the module.
It is also suggested, as common rule for an SMT component, to avoid having a mechanical
part of the application in direct contact with the module.
NOTE: In the customer application, the region under INHIBIT WIRING *1 (see
figure) must be clear from signal or ground paths.