User's Manual

GE865 Hardware User Guide
1vv0300799 Rev.11 – 13-07-2010
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 66 of 82
12.1.2 Enabling DAC
An AT command is available to use the DAC function.
The command is: AT#DAC= [ <enable > [, <value> ]]
<value> - scale factor of the integrated output voltage (0..1023 - 10 bit precision)
it must be present if <enable>=1
Refer to SW User Guide or AT Commands Reference Guide for the full description of
this function.
NOTE:
The DAC frequency is selected internally. D/A converter must not be used during
POWERSAVING.
12.1.3 Low Pass Filter Example