User's Manual

GE864
GE864GE864
GE864-
--
-QUAD Automotive V2 Hardware User Guide
QUAD Automotive V2 Hardware User GuideQUAD Automotive V2 Hardware User Guide
QUAD Automotive V2 Hardware User Guide
1vv0300840 Rev.3 2010-04-08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 14 of 71
Ball
BallBall
Ball Si
SiSi
Signal
gnalgnal
gnal I/O
I/OI/O
I/O Function
FunctionFunction
Function Internal PULL UP
Internal PULL UPInternal PULL UP
Internal PULL UP Type
TypeType
Type
G7
G7G7
G7 - - Reserved
G11
G11G11
G11 - - Reserved
H4
H4H4
H4 - - Reserved
H6
H6H6
H6 - - Reserved
H7
H7H7
H7 - - Reserved
J4
J4J4
J4 - - Reserved
J6
J6J6
J6 - - Reserved
J7
J7J7
J7 - - Reserved
K9
K9K9
K9 - - Reserved
K10
K10K10
K10 - - Reserved
K11
K11K11
K11 - - Reserved
L5
L5L5
L5 - - Reserved
L7
L7L7
L7 - - Reserved
L10
L10L10
L10 - - Reserved
* Ref. to Digital Voice Interface Application Note 80000NT10004a.
NOTE:
NOTE:NOTE:
NOTE:
RESERVED pins must not be connected
NOTE:
NOTE:NOTE:
NOTE:
RTS must be connected to the GND (on the module side) if flow control is not used.
NOTE:
NOTE:NOTE:
NOTE:
If not used, almost all pins should be left disconnected. The only exceptions are the
following pins:
pin
pinpin
pin signal
signalsignal
signal
J1,K1,J2,K2
J1,K1,J2,K2J1,K1,J2,K2
J1,K1,J2,K2 VBATT
A1,F1,H1,L1,H2,L2,J3,K3,L3,
A1,F1,H1,L1,H2,L2,J3,K3,L3,A1,F1,H1,L1,H2,L2,J3,K3,L3,
A1,F1,H1,L1,H2,L2,J3,K3,L3,
K4,K5,D6,K6,L6,A1
K4,K5,D6,K6,L6,A1K4,K5,D6,K6,L6,A1
K4,K5,D6,K6,L6,A11,F11,L11
1,F11,L111,F11,L11
1,F11,L11
GND
J5
J5J5
J5 ON/OFF*
E7
E7E7
E7 TXD
A2
A2A2
A2 RESET*
H8
H8H8
H8 RXD