User's Manual

GE864

GE864GE864

GE864-

-QUAD V2 / GE864

QUAD V2 / GE864QUAD V2 / GE864

QUAD V2 / GE864-

-DUAL V2 Hardware User Guide

DUAL V2 Hardware User GuideDUAL V2 Hardware User Guide

DUAL V2 Hardware User Guide

1vv0300875 Rev.1 – 2010-03-29

15. SAFETY RECOMMENDATIONS

NOTE:

NOTE:NOTE:

NOTE:

Read this section carefully to ensure the safe operation.

Be sure the use of this product is allowed in the country and in the environment

required. The use of this product may be dangerous and has to be avoided in the

following areas:

• Where it can interfere with other electronic devices in environments such

as hospitals, airports, aircrafts, etc

• Where there is risk of explosion such as gasoline stations, oil refineries,

etc

It is responsibility of the user to enforce the country regulation and the specific

environment regulation.

Do not disassemble the product; any mark of tampering will compromise the

warranty validity.

We recommend following the instructions of the hardware user guides for a correct

wiring of the product. The product has to be supplied with a stabilized voltage source

and the wiring has to be conforming to the security and fire prevention regulations.

The product has to be handled with care, avoiding any contact with the pins because

electrostatic discharges may damage the product itself. Same cautions have to be

taken for the SIM, checking carefully the instruction for its use. Do not insert or

remove the SIM when the product is in power saving mode.

The system integrator is responsible of the functioning of the final product;

therefore, care has to be taken to the external components of the module, as well as

of any project or installation issue, because the risk of disturbing the GSM network or

external devices or having impact on the security. Should there be any doubt, please

refer to the technical documentation and the regulations in force.

Every module has to be equipped with a proper antenna with specific characteristics.

The antenna has to be installed with care in order to avoid any interference with

other electronic devices and has to guarantee a minimum distance from the body (20

cm). In case of this requirement cannot be satisfied, the system integrator has to

assess the final product against the SAR regulation EN 50360.