User's Manual
GE864
GE864GE864
GE864-
--
-QUAD V2 / GE864
QUAD V2 / GE864QUAD V2 / GE864
QUAD V2 / GE864-
--
-DUAL V2 Hardware User Guide
DUAL V2 Hardware User GuideDUAL V2 Hardware User Guide
DUAL V2 Hardware User Guide
1vv0300875 Rev.1 – 2010-03-29
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved. Page 61 of 73
11.12.2. Using ADC Converter
The AT command below is available to use the ADC function:
AT#ADC=1,2
AT#ADC=1,2AT#ADC=1,2
AT#ADC=1,2
The read value is expressed in mV.
Refer to SW User Guide or AT Commands Reference Guide for the full description of
this function.
11.13.
11.13.11.13.
11.13. Debug of the
Debug of the Debug of the
Debug of the GE864
GE864GE864
GE864-
--
-QUAD V2 / GE864
QUAD V2 / GE864QUAD V2 / GE864
QUAD V2 / GE864-
--
-DUAL V2
DUAL V2DUAL V2
DUAL V2 in
in in
in
Production
ProductionProduction
Production
To test and debug the mounting of the GE864-QUAD V2 / GE864-DUAL, we strongly
recommend to foreseen test pads on the host PCB, in order to check the connection
between the GE864-QUAD V2 / GE864-DUAL V2 itself and the application and to test
the performance of the module connecting it with an external computer. Depending
by the customer application, these pads include, but are not limited to the following
signals:
Ball
BallBall
Ball
Signal
SignalSignal
Signal
Function
FunctionFunction
Function
J
JJ
J1
11
1, J
, J, J
, J2
22
2, K1, K2
, K1, K2, K1, K2
, K1, K2
VBATT Main power supply
A1, A11, D6, F1, F11,
A1, A11, D6, F1, F11, A1, A11, D6, F1, F11,
A1, A11, D6, F1, F11,
H1, H2, J3, K3, K4,
H1, H2, J3, K3, K4, H1, H2, J3, K3, K4,
H1, H2, J3, K3, K4,
K5, K6, L1,
K5, K6, L1,K5, K6, L1,
K5, K6, L1, L2, L3,
L2, L3, L2, L3,
L2, L3,
L6, L11
L6, L11L6, L11
L6, L11
GND Ground
E7
E7E7
E7
C103/TXD Serial data input (TXD) from DTE
H8
H8H8
H8
C104/RXD Serial data output (RXD) to DTE
L8
L8L8
L8
PRWMON Power ON Monitor
J5
J5J5
J5
ON/OFF* Input command for switching power ON or OFF (toggle command).
A2
A2A2
A2
RESET* Reset input
F10
F10F10
F10
RX_TRACE RX Data for debug monitor
D11
D11D11
D11
TX_TRACE TX Data for debug monitor
H4
H4H4
H4
SERVICE SERVICE connection