User's Manual

GE864
GE864GE864
GE864-
--
-QUAD V2 / GE864
QUAD V2 / GE864QUAD V2 / GE864
QUAD V2 / GE864-
--
-DUAL V2 Hardware User Guide
DUAL V2 Hardware User GuideDUAL V2 Hardware User Guide
DUAL V2 Hardware User Guide
1vv0300875 Rev.1 – 2010-03-29
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved. Page 16 of 73
NOTE
NOTENOTE
NOTE:
::
:
If not used, almost all pins must be left disconnected. The only exceptions are the
following pins:
Ball
BallBall
Ball Signal
SignalSignal
Signal Function
FunctionFunction
Function
J
JJ
J1
11
1, J
, J, J
, J2
22
2, K1, K2
, K1, K2, K1, K2
, K1, K2 VBATT Main power supply
A1, A11, D6, F1, F11, H1,
A1, A11, D6, F1, F11, H1, A1, A11, D6, F1, F11, H1,
A1, A11, D6, F1, F11, H1,
H2, J3, K3, K4, K5
H2, J3, K3, K4, K5H2, J3, K3, K4, K5
H2, J3, K3, K4, K5, K6, L1,
, K6, L1, , K6, L1,
, K6, L1,
L2, L3, L6, L11
L2, L3, L6, L11L2, L3, L6, L11
L2, L3, L6, L11
GND Ground
E7
E7E7
E7 C103/TXD Serial data input (TXD) from DTE
H8
H8H8
H8 C104/RXD Serial data output to DTE
F7
F7F7
F7 C105/RTS Input for Request to send signal (RTS) from DTE
J5
J5J5
J5 ON/OFF* Input command for switching power ON or OFF (toggle command).
A2
A2A2
A2 RESET* Reset input
F10
F10F10
F10 RX_TRACE RX Data for debug monitor
D11
D11D11
D11 TX_TRACE TX Data for debug monitor
H4
H4H4
H4 SERVICE SERVICE connection