User's Manual
Table Of Contents
- 1 Overview
- 2 GE864-QUAD V2 Mechanical Dimensions
- 3 GE864-QUAD V2 module connections
- 4 Hardware Commands
- 5 Power Supply
- 6 Antenna
- 7 Logic level specifications
- 8 Serial Ports
- 9 Audio Section Overview
- 10 General Purpose I/O
- 10.1 GPIO Logic levels
- 10.2 Using a GPIO Pad as INPUT
- 10.3 Using a GPIO Pad as OUTPUT
- 10.4 Using the RF Transmission Control GPIO4
- 10.5 Using the RFTXMON Output GPIO5
- 10.6 Using the Alarm Output GPIO6
- 10.7 Using the Buzzer Output GPIO7
- 10.8 Indication of network service availability
- 10.9 RTC Bypass out
- 10.10 External SIM Holder Implementation
- 11 DAC and ADC section
- 12 Conformity Assessment Issues
- 14 Document Change Log
GE864-QUAD V2 Hardware User Guide
1vv0300841 Rev.0.1 24/11/09
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 47 of 65
10.2 Using a GPIO Pad as INPUT
The GPIO pads, when used as inputs, can be connected to a digital output of another device and
report its status, provided this device has interface levels compatible with the 2.8V CMOS levels of the
GPIO.
If the digital output of the device to be connected with the GPIO input pad has interface levels different
from the 2.8V CMOS, then it can be buffered with an open collector transistor with a 47K pull up to
2.8V.
10.3 Using a GPIO Pad as OUTPUT
The GPIO pads, when used as outputs, can drive 2.8V CMOS digital devices or compatible hardware.
When set as outputs, the pads have a push-pull output and therefore the pull-up resistor may be
omitted.
10.4 Using the RF Transmission Control GPIO4
The GPIO4 pin, when configured as RF Transmission Control Input, permits to disable the Transmitter
when the GPIO is set to Low by the application.
In the design is necessary to add a pull up resistor (47K to PWRMON);