User's Manual
Table Of Contents
- 1 Overview
- 2 GE864-QUAD V2 Mechanical Dimensions
- 3 GE864-QUAD V2 module connections
- 4 Hardware Commands
- 5 Power Supply
- 6 Antenna
- 7 Logic level specifications
- 8 Serial Ports
- 9 Audio Section Overview
- 10 General Purpose I/O
- 10.1 GPIO Logic levels
- 10.2 Using a GPIO Pad as INPUT
- 10.3 Using a GPIO Pad as OUTPUT
- 10.4 Using the RF Transmission Control GPIO4
- 10.5 Using the RFTXMON Output GPIO5
- 10.6 Using the Alarm Output GPIO6
- 10.7 Using the Buzzer Output GPIO7
- 10.8 Indication of network service availability
- 10.9 RTC Bypass out
- 10.10 External SIM Holder Implementation
- 11 DAC and ADC section
- 12 Conformity Assessment Issues
- 14 Document Change Log
GE864-QUAD V2 Hardware User Guide
1vv0300841 Rev.0.1 24/11/09
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 38 of 65
translation
If the OEM application uses a microcontroller with a serial port (UART) that works at a voltage different
from 2.8 - 3V, then a circuitry has to be provided to adapt the different levels of the two set of signals.
As for the RS232 translation there are a multitude of single chip translators. For example a possible
translator circuit for a 5V TRANSMITTER/RECEIVER can be:
TIP: This logic IC for the level translator and 2.8V pull-ups (not the 5V one) can be powered directly from PWRMON
line of the GE864-QUAD V2. Note that the TC7SZ07AE has open drain output, therefore the resistor R2 is mandatory.
TO TELIT
MODULE