User's Manual
Table Of Contents
- 1 Overview
- 2 GE864-QUAD V2 Mechanical Dimensions
- 3 GE864-QUAD V2 module connections
- 4 Hardware Commands
- 5 Power Supply
- 6 Antenna
- 7 Logic level specifications
- 8 Serial Ports
- 9 Audio Section Overview
- 10 General Purpose I/O
- 10.1 GPIO Logic levels
- 10.2 Using a GPIO Pad as INPUT
- 10.3 Using a GPIO Pad as OUTPUT
- 10.4 Using the RF Transmission Control GPIO4
- 10.5 Using the RFTXMON Output GPIO5
- 10.6 Using the Alarm Output GPIO6
- 10.7 Using the Buzzer Output GPIO7
- 10.8 Indication of network service availability
- 10.9 RTC Bypass out
- 10.10 External SIM Holder Implementation
- 11 DAC and ADC section
- 12 Conformity Assessment Issues
- 14 Document Change Log
GE864-QUAD V2 Hardware User Guide
1vv0300841 Rev.0.1 24/11/09
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 16 of 65
For example:
1- Let's assume you need to drive the ON* pad with a totem pole output from +1.8V up to 5V
microcontroller (uP_OUT1):
2- Let's assume you need to drive the ON* pad directly with an ON/OFF button:
1s
10k
ON*
+
1.8V ... 5V
ON*