User's Manual

GE/GC864-QUAD V2 and GE864-GPS Hardware User Guide
1vv0300915 Rev.2 – 2011-06-15
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights
Reserved. Page 95 of 97
The European Community provides some Directives for the
electronic equipments introduced on the market. All the
relevant information’s are available on the European Community
website:
http://ec.europa.eu/enterprise/sectors/rtte/documents/
The text of the Directive 99/05 regarding telecommunication
equipments is available, while the applicable Directives (Low
Voltage and EMC) are available at:
http://ec.europa.eu/enterprise/sectors/electrical
FCC Regulatory Requirements
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure:
The antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20
cm from all the persons and must not be co-located or
operating in conjunction with any other antenna or
transmitter.
The system antenna(s) used for this module must not
exceed 1,4dBi (850MHz) and 3.0dBi (1900MHz) for mobile
and fixed or mobile operating configurations.
Users and installers must be provided with antenna
installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
A label containing the following information must be
affixed to the outside of a host product which
incorporates this module:
Label Module type
Contains FCC ID:
RI7G
E
86
Q
2
For GE864
-
QUAD V2
Contains FCC ID:
RI7G
C
864
Q
2
For CE864-QUAD V2
Contains FCC ID: RI7GE864G2
For GE864-GPS