User's Manual

GE/GC864-QUAD V2 and GE864-GPS Hardware User Guide
1vv0300915 Rev.2 – 2011-06-15
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights
Reserved. Page 94 of 97
17. SAFETY RECOMMANDATIONS
READ CAREFULLY
Be sure the use of this product is allowed in the country and
in the environment required. The use of this product may be
dangerous and has to be avoided in the following areas:
 Where it can interfere with other electronic devices in
environments such as hospitals, airports, aircrafts, etc
 Where there is risk of explosion such as gasoline stations,
oil refineries, etc
It is responsibility of the user to enforce the country
regulation and the specific environment regulation.
Do not disassemble the product; any mark of tampering will
compromise the warranty validity.
We recommend following the instructions of the hardware user
guides for a correct wiring of the product. The product has to
be supplied with a stabilized voltage source and the wiring
has to be conforming to the security and fire prevention
regulations.
The product has to be handled with care, avoiding any contact
with the pins because electrostatic discharges may damage the
product itself. Same cautions have to be taken for the SIM,
checking carefully the instruction for its use. Do not insert
or remove the SIM when the product is in power saving mode.
The system integrator is responsible of the functioning of the
final product; therefore, care has to be taken to the external
components of the module, as well as of any project or
installation issue, because the risk of disturbing the GSM
network or external devices or having impact on the security.
Should there be any doubt, please refer to the technical
documentation and the regulations in force.
Every module has to be equipped with a proper antenna with
specific characteristics. The antenna has to be installed with
care in order to avoid any interference with other electronic
devices and has to guarantee a minimum distance from the body
(20 cm). In case of this requirement cannot be satisfied, the
system integrator has to assess the final product against the
SAR regulation.