User's Manual

GE/GC864-QUAD V2 and GE864-GPS Hardware User Guide
1vv0300915 Rev.2 – 2011-06-15
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights
Reserved. Page 82 of 97
13.1.2. Enabling DAC
The AT command below is available to use the DAC function:
AT#DAC[=<enable>[,<value>]]
<value> – scale factor of the integrated output voltage (0–
1023, with 10 bit precision), and it must be present if
<enable>=1.
Refer to SW User Guide or AT Commands Reference Guide for the
full description of this function.
Refer to SW User Guide or AT Commands Reference Guide for the
full description of this function.
NOTE:
The DAC frequency is selected internally. D/A converter must
not be used during POWERSAVING.
13.1.3. Low Pass Filter Example