User's Manual

GE/GC864-QUAD V2 and GE864-GPS Hardware User Guide
1vv0300915 Rev.2 – 2011-06-15
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights
Reserved. Page 8 of 97
1.4. Document Organization
This document contains the following chapters:
Chapter 1: “Introduction” provides a scope for this document,
target audience, contact and support information, and text
conventions.
Chapter 2: “Overview” provides an overview of the document.
Chapter 3: “Mechanical Dimensions”
Chapter 4: “Electrical Connections” deals with the pin out
configuration and layout.
Chapter 5: “Hardware Commands” How to operate on the module
via hardware.
Chapter 6: “Power supply” Power supply requirements and
general design rules.
Chapter 7: “Antenna” The antenna connection and board layout
design are the most important parts in the full product design
Chapter 8: “Logic Level specifications” Specific values
adopted in the implementation of logic levels for the modules.
Chapter 9: “Serial ports” The serial port on the modules is
the core of the interface between the module and OEM hardware
Chapter 10: “Audio Section overview” Refers to the audio
blocks of the Base Band Chip of the modules.
Chapter 11: “General Purpose I/O” How the general purpose I/O
pads can be configured.
Chapter 12: “GPS Features (GE864-GPS only)”
Chapter 13: “DAC and ADC Converter” How the DAC and ADC pads can
be configured.
Chapter 14: “Mounting the GE/GC864-QUAD V2 AND GE864-GPS on the
application board” Recommendations and specifics on how to
mount the modules on the user’s board.
Chapter 15: “Packing System”: deals about the GE/GC864 family
packaging suystems
Chapter 16: “Conformity Assessment Issues”: refer the
compliance with reference standards