User's Manual

GE/GC864-QUAD V2 and GE864-GPS Hardware User Guide
1vv0300915 Rev.2 – 2011-06-15
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights
Reserved. Page 75 of 97
11.7. Using the Buzzer Output GPIO7
The GPIO7 pad, when configured as Buzzer Output, is controlled
by the GE/GC 864 QUAD V2 module and will drive with
appropriate square waves a Buzzer driver.
This permits to your application to easily implement Buzzer
feature with ringing tones or melody played at the call
incoming, tone playing on SMS incoming or simply playing a
tone or melody when needed by your application.
A sample interface scheme is included below to give you an
idea of how to interface a Buzzer to the GPIO7:
NOTE:
To correctly drive a buzzer a driver must be provided, its
characteristics depend on the Buzzer and for them refer to
your buzzer vendor.