User's Manual

GE/GC864-QUAD V2 and GE864-GPS Hardware User Guide
1vv0300915 Rev.2 – 2011-06-15
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights
Reserved. Page 18 of 97
Ball Signal I/O Function
Internal
PULL UP
Type
E3
- - Reserved
E4
- - Reserved
E5
- - Reserved
E8
- - Reserved
F2
- - Reserved
F3
- - Reserved
F4
- - Reserved
F5
- - Reserved
G1
- - Reserved
G3
- - Reserved
G4
- - Reserved
G5
- - Reserved
G6
(2)
- -
Reserved
(2)
G7
- - Reserved
G11
- - Reserved
H6
- - Reserved
H7
- - Reserved
J6
- - Reserved
J7
- - Reserved
K9
- - Reserved
K10
- - Reserved
L5
- - Reserved
L7
- - Reserved
L10
- - Reserved
* Ref. to Digital Voice Interface Application Note
80000NT10004a.
(1) Available only on GE864-GPS (in case of GE864-QUAD it has
to be considered RESERVED
NOTE:
The GE864-QUAD V2/GPS Modules has one DVI port on the system.
NOTE:
Reserved pins must not be connected.
(2) Only for GE864-GPS connect the G6 ball (although declared
reserved) must be connected to ground (suggested through a 0
ohm resistor) and C6 ball (although declared reserved) must be
connected to VAUX (Ball D5) through a pull up resistor (e.g.
47K).