User's Manual

INTRODUCTION
DE5468U 7
Multi
MultiMulti
Multi-
--
-Function Transmitter
Function TransmitterFunction Transmitter
Function Transmitter
Your system responds to signals sent by either a 4-
button (MCT- 234) or a 6-button two-way (MCT- 237)
miniature ‘keyfob’ transmitter that you and other
users can carry (see figure 4). Your installer can
program the AUX (auxiliary) buttons to perform
various tasks, as required.
DISARM
AWAY
AUX
HOME
DISPLAY
DISARM
STATUS /
PARTITION
(OPTION)
AUX 2
AUX 1
HOME
AWAY
Figure 4. MCT-234 and MCT-237 Keyfob Transmitters
Pressing AWAY and HOME together for 2 sec.
initiates PANIC alarm. Pressing AWAY twice within 2
seconds initiates Latchkey arming.
A. Controlling a gate or another electrical
device: Pressing the AUX button opens/closes
an electrically-controlled gate, or controls a
chosen electrical device.
B. Arming the system in the INSTANT mode
(without an entry delay): Pressing the AUX
button immediately after arming, during exit
delay, causes the system to be armed without
an entry delay. This means that entering the
protected premises via any zone will trigger an
immediate alarm. You and other holders of
keyfob transmitters will have no problem,
because you can disarm the system before
entering by pressing the DISARM (
) button on
your transmitter before entry.
C. Getting status information: Upon pressing the
AUX button on your transmitter, the voice
module announces the system status over the
loudspeaker.
Disarming by a keyfob whose battery voltage is
low
If you try to disarm the system with a keyfob whose
battery voltage is low, a protest beep will be heard for
15 seconds (if this beep is enabled by the installer).
During this period you should press again the disarm
button of the keyfob or control panel (for the control
panel, user code is required) to disarm the system. If
you perform this action during the 15 seconds period,
the Low Bat message will be stored in the event log.
If the disarm button is not pressed again during the
15 seconds period, perform either of the following
actions:
A. Press AWAY twice to arm the system, otherwise
the system will not be armed and an
acknowledgement (from the user that he knows
about the Low Bat) will not be stored in the event
log.
B. Press AWAY and then press disarm button, to
acknowledge, otherwise the acknowledgement
will not be stored in the event log.
Voice Announcements
Voice AnnouncementsVoice Announcements
Voice Announcements
The pre-recorded voice announcements respond to
your commands by announcing what the system is
doing and by prompting you to perform certain
actions. They also announce alarms, troubles and
identify the source of each event.
Screen Saver Option
Screen Saver OptionScreen Saver Option
Screen Saver Option
The Screen Saver option (if enabled by the installer)
causes that when no key is pressed during more
than 30 seconds, the display is “PowerMax” and the
LEDs do not light (to prevent an intruder to know the
system status). The normal display returns after
pressing the
button followed by entering user
code (Refresh by Code) or after pressing any key
(Refresh by Key), as selected by the installer.
If Refresh by Key was selected, the first pressing of
any key (except Fire and Emergency) causes normal
display return and the second press performs the key
function. Regarding the Fire and Emergency keys,
the first key press causes normal display return and
also
performs the Fire/Emergency function.