User's Manual

USER SETTINGS
28 DE5468U
Note that the dark box at the far right has
disappeared. It is now possible to enroll a new ID. It
is also possible to leave the cleared zone or memory
location free and simply exit to the main menu.
Setting the Voice Options
Setting the Voice OptionsSetting the Voice Options
Setting the Voice Options
Remember: Voice prompts are heard over the built-
in loudspeaker subject to two conditions:
- The voice option is enabled as shown below
- The loudspeaker is enabled by pressing the “7”
key (see Chapter 3 - Voice ON-OFF)
Here you may select one of two options:
Enable prompts: Voice announcements
Disable prompts: No voice announcements
The presently programmed option will be shown, with
a dark selection box (
) at the far right of the
display. You may view the other option (that does not
have a dark box at the far right) by clicking
. A dark box will appear if you click
while the other option is displayed.
To set the voice option, proceed as follows:
Having entered your Master User Code
successfully
(see above - Entering the User Settings Menu), click
the
button until the display reads:
SET VOICE OPTIONS
From here, proceed as follows:
PRESS
RESULTANT DISPLAY
enable prompts
(if this is the current option)
disable prompts
If not satisfied
disable prompts
If satisfied -
SET VOICE OPTION
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
. When <OK> TO EXIT is displayed - click
.
Note: When using the Model MCT-234 or MCT-
237 keyfob with the PowerMax Pro, the voice
prompts must be enabled.
Automatic Arming Option
Automatic Arming OptionAutomatic Arming Option
Automatic Arming Option
You can determine that the system will be
automatically armed at any desired time.
Having entered master user code successfully, click
until AUTO ARM OPTION is
displayed.
From here, proceed as follows:
PRESS
RESULTANT DISPLAY
enable autoarm
(if this is the current option)
disable autoarm
If not satisfied
press
disable autoarm
AUTO ARM OPTION
You may now select any other item on USERS
SETTINGS menu or quit programming process by
clicking
. When "<OK> TO EXIT" is
displayed, click
.
Setting Arming Time
Setting Arming TimeSetting Arming Time
Setting Arming Time
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
button (repeatedly, if necessary) until
the display will read:
AUTO ARM TIME
From here, proceed as follows:
PRESS
RESULTANT DISPLAY
arm time_ _ : _ _ A
arm time 12:55 A
[time
digits] (e.g.
12:55 A)
arm time 12:55 A
AUTO ARM TIME
Notes:
1. For 12h/24h time format selection, refer to
Setting Time and Time Format below.
2. Press "(" to enter A (AM), or press "#" to enter P
(PM).
Enabling the Squawk Option
Enabling the Squawk OptionEnabling the Squawk Option
Enabling the Squawk Option
You can determine that the system will activate (or
not activate) high/mid/low siren sound, for a short
time, upon arming (1 beep) and disarming (2 beeps),
by keyfob only.
Having entered your Master User Code
successfully
(see above - Entering the User Settings Menu), click
the
button (repeatedly, if necessary)
until the display will read:
SQUAWK OPTION