User's Manual

Telit GE863-QUAD / GE863-PY
Hardware User guide
1vv0300697, Rev. ISSUE#0, - 21/11/05
Reproduction forbidden without Telit Communication written authorization – All Right reserved – Right of modification reserved page 47 of 70
32 IICSDA GPIO4 I/O IICbus serial data 3 S_DATA I/O
53 CAM_DRDY
GPIO5
I Data ready in an output for the camera
and an input for the GE863-QUAD
7 DR O
31 VOUT O power supply for the camera 2 VCC_MAIN I
- - - Horizontal sync n.c. 6 HSYNC O
51 OE_CAM
GPIO7
O Input command for switching power
ON or OFF
5 ON_OFF I
56-
..
GND Ground 1-18 GND
NOTE: The CMOS camera must be removed when the GPIO pads are used for I/O purpose.
NOTE: The white point on the ADCM2650 camera cable have to match with pad18 on ZIF connector.