User's Manual
Table Of Contents
- GC864 Hardware User Guide
- APPLICABILITY TABLE
- 1. Introduction
- 2. Overview
- 3. GC864 Mechanical Dimensions
- 4. GC864-QUAD/PY Module Connections
- 5. Hardware Commands
- 6. Power Supply
- 7. Antenna
- 8. Logic Level Specifications
- 9. Serial Ports
- 10. Audio Section Overview
- 11. General Purpose I/O
- 11.1. GPIO Logic Levels
- 11.2. Using a GPIO Pad as INPUT
- 11.3. Using a GPIO Pad as OUTPUT
- 11.4. Using the RF Transmission Control GPIO4
- 11.5. Using the RFTXMON Output GPIO5
- 11.6. Using the Alarm Output GPIO6
- 11.7. Using the Buzzer Output GPIO7
- 11.8. Magnetic Buzzer Concepts
- 11.9. Using the Temperature Monitor Function
- 11.10. Indication of Network Service Availability
- 11.11. RTC Bypass Out
- 11.12. VAUX1 Power Output
- 12. DAC and ADC Section
- 13. Mounting the GC864-QUAD/PY on the Board
- 14. Packing System
- Conformity Assessment Issues
GC864 Hardware User Guide
1vv0300733 Rev.12 – 2009-06-04
15. Conformity Assessment Issues
The Telit GC864 has been assessed in order to satisfy the
essential requirements of the R&TTE Directive 1999/05/EC (Radio
Equipment & Telecommunications Terminal Equipments) to
demonstrate the conformity against the harmonized standards with the
final involvement of a Notified Body.
If the module is installed in conformance to the Telit installation manuals, no further
evaluation under Article 3.2 of the R&TTE Directive and do not require further
involvement of a R&TTE Directive Notified Body for the final product.
In all other cases, or if the manufacturer of the final product is in doubt, then the
equipment integrating the radio module must be assessed against Article 3.2 of the
R&TTE Directive.
In all cases the assessment of the final product must be made against the Essential
requirements of the R&TTE Directive Articles 3.1(a) and (b), Safety and EMC
respectively, and any relevant Article 3.3 requirements.
This Product Description, the Hardware User Guide and Software User Guide contain
all the information you may need for developing a product meeting the R&TTE
Directive.
Furthermore the GC864 module is FCC Approved as module to be installed in other
devices. This device is to be used only for fixed and mobile applications. If the final
product after integration is intended for portable use, a new application and FCC is
required.
The GC864 is conforming to the following US Directives:
• Use of RF Spectrum. Standards: FCC 47 Part 24 (GSM 1900)
• EMC (Electromagnetic Compatibility). Standards: FCC47 Part 15
0168
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 66 of 69