User's Manual

Table Of Contents
GC864 Hardware User Guide
1vv0300733 Rev.12 – 2009-06-04
The set command could be used also with one of the following GPIO but in that case
the alternate function is not usable:
Signal Function Type
Input /
output
current
Note
TGPIO_02 GPIO02 Configurable GPIO CMOS 2.8V
1A / 1mA
Alternate function (JDR)
TGPIO_04 GPIO04 Configurable GPIO CMOS 2.8V 1A / 1mA
Alternate function (RF
Transmission Control)
TGPIO_05 GPIO05 Configurable GPIO CMOS 2.8V 1A / 1mA Alternate function (RFTXMON)
TGPIO_07 GPIO07 Configurable GPIO CMOS 2.8V 1A / 1mA Alternate function (BUZZER)
11.10. Indication of Network Service Availability
The STAT_LED pin status shows information on the network service availability and Call
status.
In the GC864-QUAD/PY modules, the STAT_LED usually needs an external transistor to drive
an external LED.
Therefore, the status indicated in the following table is reversed with respect to the pin
status.
LED status Device Status
Permanently off Device off
Fast blinking
(Period 1s, Ton 0,5s)
Net search / Not registered /
turning off
Slow blinking
(Period 3s, Ton 0,3s)
Registered full service
Permanently on a call is active
A schematic example could be:
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 58 of 69