User's Manual
Table Of Contents
- GC864 Hardware User Guide
- APPLICABILITY TABLE
- 1. Introduction
- 2. Overview
- 3. GC864 Mechanical Dimensions
- 4. GC864-QUAD/PY Module Connections
- 5. Hardware Commands
- 6. Power Supply
- 7. Antenna
- 8. Logic Level Specifications
- 9. Serial Ports
- 10. Audio Section Overview
- 11. General Purpose I/O
- 11.1. GPIO Logic Levels
- 11.2. Using a GPIO Pad as INPUT
- 11.3. Using a GPIO Pad as OUTPUT
- 11.4. Using the RF Transmission Control GPIO4
- 11.5. Using the RFTXMON Output GPIO5
- 11.6. Using the Alarm Output GPIO6
- 11.7. Using the Buzzer Output GPIO7
- 11.8. Magnetic Buzzer Concepts
- 11.9. Using the Temperature Monitor Function
- 11.10. Indication of Network Service Availability
- 11.11. RTC Bypass Out
- 11.12. VAUX1 Power Output
- 12. DAC and ADC Section
- 13. Mounting the GC864-QUAD/PY on the Board
- 14. Packing System
- Conformity Assessment Issues
GC864 Hardware User Guide
1vv0300733 Rev.12 – 2009-06-04
9.3. 5V UART Level Translation
If the OEM application uses a microcontroller with a serial port (UART) that works at
a voltage different from 2.8 – 3V, then a circuitry has to be provided to adapt the
different levels of the two set of signals. As for the RS232 translation there are a
multitude of single chip translators. For example a possible translator circuit for a 5V
TRANSMITTER/RECEIVER can be:
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 43 of 69