User's Manual
Table Of Contents
- GC864 QUAD V2andGC864 DUAL V2Hardware User Guide
- APPLICABILITY TABLE
- 1 Introduction
- 2. Overview
- 3. GC864 Mechanical Dimensions
- 4. GC864-QUAD V2 / GC864-DUAL V2 Module Connections
- 5. Hardware Commands
- 6. Power Supply
- 7. Antenna
- 8. Logic Level Specifications
- 9. Serial Ports
- 10. Audio Section Overview
- 11. General Purpose I/O
- 11.1. GPIO Logic Levels
- 11.2. Using a GPIO Pad as INPUT
- 11.3. Using a GPIO Pad as OUTPUT
- 11.4. Using the RF Transmission Control GPIO4
- 11.5. Using the RFTXMON Output GPIO5
- 11.6. Using the Alarm Output GPIO6
- 11.7. Using the Buzzer Output GPIO7
- 11.8. Magnetic Buzzer Concepts
- 11.9. Using the Temperature Monitor Function
- 11.10. Indication of Network Service Availability
- 11.11. RTC Bypass Out
- 11.12. DAC Converter
- 11.13. ADC Converter
- 12. Assembly the GC864-QUAD V2 / GC864-DUAL V2 on the Board
- 13. Packing System
- 14. Conformity Assessment Issues
GC864 Hardware User Guide
1vv0300874 Rev.0 – 2010-01-25
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved. Page 62 of 64
• The system antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all the persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
• The system antenna(s) used for this module must not exceed 1.4dBi (850MHz) and
3.0dBi (1900MHz) for mobile and fixed or mobile operating configurations.
• Users and installers must be provided with antenna installation instructions and
transmitter operating conditions for satisfying RF exposure compliance.
Manufacturers of mobile, fixed or portable devices incorporating this module are
advised to clarify any regulatory questions and to have their complete product tested
and approved for FCC compliance.