User's Manual
Table Of Contents
- GC864 QUAD V2andGC864 DUAL V2Hardware User Guide
- APPLICABILITY TABLE
- 1 Introduction
- 2. Overview
- 3. GC864 Mechanical Dimensions
- 4. GC864-QUAD V2 / GC864-DUAL V2 Module Connections
- 5. Hardware Commands
- 6. Power Supply
- 7. Antenna
- 8. Logic Level Specifications
- 9. Serial Ports
- 10. Audio Section Overview
- 11. General Purpose I/O
- 11.1. GPIO Logic Levels
- 11.2. Using a GPIO Pad as INPUT
- 11.3. Using a GPIO Pad as OUTPUT
- 11.4. Using the RF Transmission Control GPIO4
- 11.5. Using the RFTXMON Output GPIO5
- 11.6. Using the Alarm Output GPIO6
- 11.7. Using the Buzzer Output GPIO7
- 11.8. Magnetic Buzzer Concepts
- 11.9. Using the Temperature Monitor Function
- 11.10. Indication of Network Service Availability
- 11.11. RTC Bypass Out
- 11.12. DAC Converter
- 11.13. ADC Converter
- 12. Assembly the GC864-QUAD V2 / GC864-DUAL V2 on the Board
- 13. Packing System
- 14. Conformity Assessment Issues
GC864 Hardware User Guide
1vv0300874 Rev.0 – 2010-01-25
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved. Page 61 of 64
14. Conformity Assessment Issues
The Telit GC864-QUAD V2 has been assessed in order to
satisfy the essential requirements of the R&TTE Directive
1999/05/EC (Radio Equipment & Telecommunications
Terminal Equipments) to demonstrate the conformity against
the harmonized standards with the final involvement of a
Notified Body.
If the module is installed in conformance to the Telit installation manuals, no further
evaluation under Article 3.2 of the R&TTE Directive and do not require further
involvement of a R&TTE Directive Notified Body for the final product.
In all other cases, or if the manufacturer of the final product is in doubt, then the
equipment integrating the radio module must be assessed against Article 3.2 of the
R&TTE Directive.
In all cases the assessment of the final product must be made against the Essential
requirements of the R&TTE Directive Articles 3.1(a) and (b), Safety and EMC
respectively, and any relevant Article 3.3 requirements.
This Hardware User Guide contains all the information you may need for developing a
product meeting the R&TTE Directive.
Furthermore the GC864-QUAD V2 module is FCC Approved as module to be installed
in other devices. This device is to be used only for fixed and mobile applications. If the
final product after integration is intended for portable use, a new application and FCC
is required.
The GC864-QUAD V2 is conforming to the following US Directives:
• Use of RF Spectrum. Standards: FCC 47 Part 24 (GSM 1900)
• EMC (Electromagnetic Compatibility). Standards: FCC47 Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
To meet the FCC's RF exposure rules and regulations: