User's Manual
Table Of Contents
- GC864 QUAD V2andGC864 DUAL V2Hardware User Guide
- APPLICABILITY TABLE
- 1 Introduction
- 2. Overview
- 3. GC864 Mechanical Dimensions
- 4. GC864-QUAD V2 / GC864-DUAL V2 Module Connections
- 5. Hardware Commands
- 6. Power Supply
- 7. Antenna
- 8. Logic Level Specifications
- 9. Serial Ports
- 10. Audio Section Overview
- 11. General Purpose I/O
- 11.1. GPIO Logic Levels
- 11.2. Using a GPIO Pad as INPUT
- 11.3. Using a GPIO Pad as OUTPUT
- 11.4. Using the RF Transmission Control GPIO4
- 11.5. Using the RFTXMON Output GPIO5
- 11.6. Using the Alarm Output GPIO6
- 11.7. Using the Buzzer Output GPIO7
- 11.8. Magnetic Buzzer Concepts
- 11.9. Using the Temperature Monitor Function
- 11.10. Indication of Network Service Availability
- 11.11. RTC Bypass Out
- 11.12. DAC Converter
- 11.13. ADC Converter
- 12. Assembly the GC864-QUAD V2 / GC864-DUAL V2 on the Board
- 13. Packing System
- 14. Conformity Assessment Issues
GC864 Hardware User Guide
1vv0300874 Rev.0 – 2010-01-25
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved. Page 15 of 64
Pin Signal I/O Function
Internal
Pull up
Type
RESERVED
17 Reserved -
33 Reserved -
34 Reserved -
35 Reserved -
41 Reserved -
42 Reserved -
43 Reserved -
44 Reserved -
48 Reserved
-
50 Reserved -
51 Reserved
-
52 Reserved
-
56 Reserved
-
57 Reserved
-
58 Reserved
-
60 Reserved
-
61 Reserved
-
62 Reserved
-
64 Reserved
-
69 Reserved -
72 Reserved
-
75 Reserved
-
77 Reserved
-
79 Reserved -
80 Reserved -
NOTE:
The GC864-QUAD V2 / GC864-DUAL V2 Modules has one DVI ports on the system
interface.
NOTE:
Reserved pins must not be connected.