User's Manual

CE910 Family Hardware User Guide
1vv0301010 Rev.11 – 2015-10-27
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 71 of 75
gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
L'émetteur radio (CE910-DUAL identification d'IC : 5131A-CE910DUAL & CE910B-
DUAL identification d'IC : 5131A-CE910BDUAL) a été approuvé par Industry Canada pour
fonctionner avec le type d'antenne énuméré dans ce manuel avec le gain autorisé maximum et
l'impédance d’antenne exigée pour chaque type d'antenne indiqué. Les types d'antenne non
inclus dans cette liste, ayant un gain supérieur au gain maximum indiqué pour ce type, sont
strictement interdits pour un usage avec ce dispositif.
The following regulatory and safety notices must be published in documentation supplied to the
end user of the product or system incorporating an adapter in compliance with local regulations.
• Host system including CE910 must be labeled with
“Contains transmitter module with
CE910-DUAL FCC ID: RI7CE910-DUAL and IC ID: 5131A-CE910DUAL
CE910B-DUAL FCC ID: RI7CE910B-DUAL and IC ID: 5131A-CE910BDUAL”
Les notices de normalisation et de sécurité doivent se trouver dans la documentation fournie à
l'utilisateur du produit ou du système incorporant un adaptateur conforme aux règlementations
locales.
• Le système hôte comprenant CE910 doit être marqué avec « Contient un module
émetteur avec
CE910-DUAL IDENTIFICATION FCC : RI7CE910-DUAL et identification IC :
5131A-CE910DUAL
CE910B-DUAL IDENTIFICATION FCC : RI7CE910B-DUAL et identification IC :
5131A-CE910BDUAL »
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
•Consult the dealer or an experienced radio/TV technician for help.