User's Manual

CE910 Family Hardware User Guide
1vv0301010 Rev.11 – 2015-10-27
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 60 of 75
13.3. Recommended foot print for the application
144 pins
< Top View >
In order to easily rework the CE910 it is suggested to consider having a 1.5 mm placement inhibit
area around the module on the application.
It is also suggested, as a common rule for an SMT component, to avoid having a mechanical part of
the application in direct contact with the module.
NOTE:
In the customer application, the region under WIRING INHIBIT (see figure) must be clear from
signal or ground paths.