User's Manual

Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 54 of 73
Field size Valid Range Description Default
Status 2 0x0001-0x0003 Result of the command N/A
DXT list 1 0x00: All the active DXTs
in the network;
0x01: All the active DXTs
from the saved list
Active DXTs or DXT list N/A
bode baro 1 0x00: No data; 0x01:
Last data;0x02: All data;
0x03 Specific data
Get Last Data / All Data / Specific Data
or don’t get data
N/A
block baro 2 0-6000 Specific block N/A
mode diver 1 0x00: No data; 0x01:
Last data;0x02: All data;
0x03 Specific data
Get Last Data / All Data / Specific Data
or don’t get data
N/A
block diver 2 0-6000 Specific block N/A
4.3.4.31 Get Log File
Get Log application file over serial communication (C1 and C2) or FTP (only C2).
Log application file contains:
• the last operations done by gateway
o C1: the operations since boot are always reported
o C2: if there is an error occurred during previous autonomous mode and this has never
been sent over FTP or serial communication, the operations since this error are
reported, else the operations since boot are reported
• the actual status of the gateway
• the DXT list
If control interface is not on serial port, gateway sends log info to RS232 serial port.
OPCODE:0x001F
Where field parameters is:
FTP/serial
FTP/serial parameter is mandatory.
Field
Size
Valid Range
Description
Default
FTP/serial 1 0x00: serial, 0x01: FTP Sending file mode N/A
Get log file response (serial)
If received data length is SIZE, (SIZE/256) packets are received. Every packet is:
Status NumTotPackets Num Len Data bytes