User Manual

GE863-PRO

Product Description

80285ST10036a Rev. 1 DRAFT- 24/04/08

3.31.5 SAP: SIM Access Profile

3.31.5.1 Product architecture

The SAP feature allow the module to use the SIM of a remote SIM Server. This feature is

implemented using special AT Command on a Virtual circuit of the CMUX interface.

3.31.5.2 Implementation feature

• SAP is based on 7.10 CMUX Basic Option used

• Only SAP Client features

• Logic HW flow control is recommended on the Virtual instance selected for the SAP command.

3.31.5.3 Remote SIM Message Command Description

The module sends request commands to the client application through a binary message that is

crowned in the CMUX message. The client application shall extract the message and send it to the

SAP server, through the appropriate protocols (e.g. by RFCOMM, that is the Bluetooth serial port

emulation entity).

The client application shall extract all the messages sent by SAP server and put them in the CMUX

message, to sent to the module.

The module satisfies the following feature requirements:

• Connection management

• Transfer APDU

• Transfer ATR

• Power SIM on

• Report Status

• Error Handling

Every feature needs some procedures support:

Feature Procedure

Connect

Report Status

Transfer ATR

Disconnection Initiated by the Client

Connection Management

Disconnection Initiated by the Server

Transfer APDU Transfer APDU

Transfer ATR Transfer ATR

Power SIM on Power SIM on