Maintenance Manual
Table Of Contents
- 1 Overall Architecture Of 1x1 Test System 2.1
- 3 Firmware Burning For EVK Daughter Board
- 4 Observe Test Result Via PC Software EvkMonitor
- 5 Update PCBA (DUT) Firmware
- Appendix 1 Test Item List On PC Software “EvkMonitor”
- Appendix 2：Hardware List
- Appendix 3：Dimension chart of EVK daughter board and buzzer board
Assembly And Maintenance Manual for Telink BLE 1x1 Test System 2.1
AN-16052600-E3 5 Ver 1.2.0
1 Overall Architecture Of 1x1 Test System 2.1
Telink BLE 1x1 Test System 2.1 consists of test bench and mechanical structure.
The test bench includes hardware platform and firmware folder, and it’s provided by
Telink; while customer needs to make the mechanical structure suitable for DUT
(Device Under Test), and connect cables according to the guide in this document.
A set of 1x1 Test Bench mainly contains the following hardware resources.
1) An EVK daughter board provided by Telink. The EVK board should be burned with
the EVK firmware for test bench.
Figure 1 EVK daughter board
3) A buzzer module (Dimension: 50.2x16mm): The buzzer is connected to
corresponding GPIO and 3V3DUT of the EVK daughter board via Dupont cables.