User's Manual
Table Of Contents
- 1 Overall Architecture Of 1x1 Test System 2.1
- 2 Hardware Platform Building
- 2.1 Check External Antenna
- 2.2 Cable connection
- 2.2.1 Connection points on EVK daughter board
- 2.2.2 Cable connection between EVK daughter board and PCB antenna
- 2.2.3 Cable connection between EVK daughter board and buzzer
- 2.2.4 Cable connection between EVK daughter board and Mechanical structure
- 2.2.5 Cable connection between EVK daughter board and DUT
- 2.2.6 Other cable connection
- 3 Firmware Burning For EVK Daughter Board
- 4 Observe Test Result Via PC Software EvkMonitor
- 5 Update PCBA (DUT) Firmware
- Appendix 1 Test Item List On PC Software “EvkMonitor”
- Appendix 2:Hardware List
- Appendix 3:Dimension chart of EVK daughter board and buzzer board
Assembly And Maintenance Manual for Telink Test System 2.1
AN-16052600-E3 5 Ver 1.2.0
1 Overall Architecture Of 1x1 Test System 2.1
Telink Test System 2.1 consists of test bench and mechanical structure. The test
bench includes hardware platform and firmware folder, and it’s provided by Telink;
while customer needs to make the mechanical structure suitable for DUT (Device
Under Test), and connect cables according to the guide in this document.
A set of 1x1 Test Bench mainly contains the following hardware resources.
1) An EVK daughter board provided by Telink. The EVK board should be burned with
the EVK firmware for test bench.
2) A PCB Antenna board provided by Telink, as shown in Figure 2.
3) A buzzer module (Dimension: 50.2x16mm): The buzzer is connected to
corresponding GPIO and 3V3DUT of the EVK daughter board via Dupont cables.