User's Manual
Table Of Contents
- 1 Overall Architecture Of 1x1 Test System 2.1
- 2 Hardware Platform Building
- 2.1 Check External Antenna
- 2.2 Cable connection
- 2.2.1 Connection points on EVK daughter board
- 2.2.2 Cable connection between EVK daughter board and PCB antenna
- 2.2.3 Cable connection between EVK daughter board and buzzer
- 2.2.4 Cable connection between EVK daughter board and Mechanical structure
- 2.2.5 Cable connection between EVK daughter board and DUT
- 2.2.6 Other cable connection
- 3 Firmware Burning For EVK Daughter Board
- 4 Observe Test Result Via PC Software EvkMonitor
- 5 Update PCBA (DUT) Firmware
- Appendix 1 Test Item List On PC Software “EvkMonitor”
- Appendix 2:Hardware List
- Appendix 3:Dimension chart of EVK daughter board and buzzer board
Assembly And Maintenance Manual for Telink Test System 2.1
AN-16052600-E3 23 Ver 1.2.0
Appendix 1 Test Item List On PC Software “EvkMonitor”
Index
Name
Description
Parameter
Maintenance
Suggestion
0
CurProtection
current protection:
test DUT current
current value
Maybe soldering
problem.
Re-solder IC.
1
GpioShort
test if there is any GPIO pins
short wired
show the two pins if
there is a short;
if not, its value will
be 0
2
TpHigh
TP high/ low frequency test:
Carry out Tx modulation
calibration to ensure RF Tx
quality
cap value
RF related.
Test again; if
failed, temporarily
mark it as rejected
product, and wait
for subsequent
analysis.
3
TpLow
cap value
4
TxHiCnt
tx high frequency counting
value/power/frequency
offset/current test:
EVK receives packets
transmitted by DUT at high
frequency point, and thus to
test DUT Tx performance at
high frequency point.
Test parameters are DUT Tx
packet number, DUT Tx power,
DUT Tx frequency offset and
DUT Tx current, successively.
cnt num
5
TxHiPower
rf energy
6
TxHiFreoffset
frequency offset
7
TxHiCurrent
current value
8
TxLoCnt
tx low frequency counting
value/power/frequency
offset/current test:
EVK receives packets
transmitted by DUT at low
frequency point, and thus to
test DUT Tx performance at
low frequency point.
Test parameters are DUT Tx
packet number, DUT Tx power,
DUT Tx frequency offset and
DUT Tx current, successively.
cnt num
9
TxLoPower
rf energy
10
TxLoFreoffset
frequency offset
11
TxLoCurrent
current value