User's Manual
Table Of Contents
- 1 Overall Architecture Of 1x1 Test System 2.1
- 2 Hardware Platform Building
- 2.1 Check External Antenna
- 2.2 Cable connection
- 2.2.1 Connection points on EVK daughter board
- 2.2.2 Cable connection between EVK daughter board and PCB antenna
- 2.2.3 Cable connection between EVK daughter board and buzzer
- 2.2.4 Cable connection between EVK daughter board and Mechanical structure
- 2.2.5 Cable connection between EVK daughter board and DUT
- 2.2.6 Other cable connection
- 3 Firmware Burning For EVK Daughter Board
- 4 Observe Test Result Via PC Software EvkMonitor
- 5 Update PCBA (DUT) Firmware
- Appendix 1 Test Item List On PC Software “EvkMonitor”
- Appendix 2:Hardware List
- Appendix 3:Dimension chart of EVK daughter board and buzzer board
Assembly And Maintenance Manual for Telink Test System 2.1
AN-16052600-E3 22 Ver 1.2.0
next to the “MD5”.
2. Click the “Download” button. The target bin file automatically replaces the
previous boot.bin under the project directory, and it will be burned into the EVK
daughter board.
After firmware is burned, user can check if the firmware is successfully updated
in the EVK daughter board by clicking the “Check boot.bin” button. The result will be
available in the log window and the box next to the “Check boot.bin” button.
Firmware update success
Firmware update failure
After the firmware is successfully updated, power cycle the EVK daughter board,
then it’s ready for use.