User's Manual
Table Of Contents
- 1 Overall Architecture Of 1x1 Test System 2.1
- 2 Hardware Platform Building
- 2.1 Check External Antenna
- 2.2 Cable connection
- 2.2.1 Connection points on EVK daughter board
- 2.2.2 Cable connection between EVK daughter board and PCB antenna
- 2.2.3 Cable connection between EVK daughter board and buzzer
- 2.2.4 Cable connection between EVK daughter board and Mechanical structure
- 2.2.5 Cable connection between EVK daughter board and DUT
- 2.2.6 Other cable connection
- 3 Firmware Burning For EVK Daughter Board
- 4 Observe Test Result Via PC Software EvkMonitor
- 5 Update PCBA (DUT) Firmware
- Appendix 1 Test Item List On PC Software “EvkMonitor”
- Appendix 2:Hardware List
- Appendix 3:Dimension chart of EVK daughter board and buzzer board
Assembly And Maintenance Manual for Telink Test System 2.1
AN-16052600-E3 18 Ver 1.2.0
4 Observe Test Result Via PC Software EvkMonitor
Double click the “Monitor” folder under “System_V3.0_xxx\Script”.
Double click the “EvkMonitor.exe” to open the software interface. If a prompt
information of “NO usb device” pops up as shown below, it indicates communication
problem such as USB cable connection with the EVK and PC; though software
interface still pops up, user must check and make sure the connection is OK, then
restart the software.
After the software is started properly, the interface is shown as below:
Figure 13 EvkMonitor tool interface
1
2
3
4
5
7
8
6