User's Manual

Assembly And Maintenance Manual for Telink Test System 2.1
AN-16052600-E3 9 Ver 1.2.0
2.2.2 Cable connection between EVK daughter board and PCB antenna
The connection point “RF” on EVK daughter board should be connected with
PCB antenna board via an RF cable.
2.2.3 Cable connection between EVK daughter board and buzzer
Table 1 shows the connection correspondence between EVK daughter board
and buzzer board.
Table 1 Cable connection between EVK and buzzer
Connection points on EVK
daughter board
Connection points on buzzer board
PIN48
VCC
3V3DUT
3V3B
GND
GND
2.2.4 Cable connection between EVK daughter board and Mechanical structure
Table 2 shows the connection correspondence between EVK daughter board
and Mechanical structure.
Table 2 Cable connection between EVK and Mechanical structure
Connection points on EVK
daughter board
Connection points on Mechanical structure
LED1 Green
Green LED+
LED2 Yellow
Yellow LED+
LED3 White
White LED+
LED4 RED
Red LED+
Button
Button+
GND
Green LED-, Yellow LED-, White LED-, Red LED-, Button-