User's Guide

Telink TLSR826XDK48 User Guide
AN-18080300-E1 14 Ver 1.0.0
3.5 Test GPIOs for TLSR826XDK48
Since all GPIOs of Telink TLSR826XDK48 board are already connected to
corresponding pins of headers including J10, J21, J25, J28, J29, J31, J33, J34, J35 and
J36 (please refer to Table 1 or the schematic), user can directly test GPIO signals on
header pins.
Telink for customer
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try correct the
interference by one or more of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.