User's Guide

Telink TLSR826XDK48 User Guide
AN-18080300-E1 13 Ver 1.0.0
3.4 Test RF signal for TLSR826XDK48
Make sure three jumper caps are connected on J9, J23 and J24 of
TLSR826XDK48.
Connect PIN3, PIN5 and PIN6 of J3 with GND, SWM and 3.3V of a burning EVK,
respectively.
To test RF signal for Telink TLSR826XDK48 board, the J4 should be connected
with a spectrum analyzer via a RF cable (supplied by Telink).
Figure 6 Connection chart to test RF signal
Connect J4
Connect spectrum analyzer
J4
Connect J9, J23 and J24 with Jumper Caps.
J9
J23
J24
1) Connect PIN3 with GND
Option 2: Connect J3 with
burning key via Swire.
3) Connect PIN6 with 3.3V
3
6
J3
5
2) Connect PIN5 with SWM
Telink for customer