User's Manual

3.8.Informationontestmodesand
additionaltestingrequirements
a)Themodulartransmitterhasbeenfullytestedbythemodulegranteeon
therequirednumberofchannels,modulationtypes,andmodes,itshouldnotbe
necessaryforthehostinstallertore-testalltheavailabletransmittermodesor
settings.Itisrecommendedthatthehostproductmanufacturer,installingthe
modulartransmitter,performsomeinvestigativemeasurementstoconfirmthat
theresultingcompositesystemdoesnotexceedthespuriousemissionslimitsor
bandedgelimits(e.g.,whereadifferentantennamaybecausingadditional
emissions).
b)Thetestingshouldcheckforemissionsthatmayoccurduetotheintermixingof
emissionswiththeothertransmitters,digitalcircuitry,orduetophysical
propertiesofthehostproduct(enclosure).Thisinvestigationisespecially
importantwhenintegratingmultiplemodulartransmitterswherethecertification
isbasedontestingeachoftheminastand-aloneconfiguration.Itisimportantto
notethathostproductmanufacturersshouldnotassumethatbecausethe
modulartransmitteriscertifiedthattheydonothaveanyresponsibilityforfinal
productcompliance.
The outside of final products that contains this module device must display a
label referring to the enclosed module. This exterior label can use wording such
as: “Contains Transmitter Module FCC ID: OEOTLSR825XML32D ”,or
“Contains FCC ID: OEOTLSR825XML32D ”, Any similar wording that expresses
the same meaning may be used.
3.7.Labelandcomplianceinformation