Product Specs

Specification For Telink 8258 Mesh RCU TLSR8258MRC48
PS-19050500-E1 9 Ver 1.0.0
3 Factory Reset Mode
Factory reset mode is customizable depending on user’s requirement, and it’s not
supported by all RC demos.
After the RC is powered on, if it’s not connected to the demo dongle, the factory
reset mode (if supported) can be triggered by pressing the specific combination
buttons (to be determined) for several seconds (to be determined). The indicating LED
of the RC will blink several times (to be determined) to indicate the RC is reset to its
factory default state.
4 Pairing and Un-pairing
NOTE: The RC needs to be paired with the demo dongle before it can be used. Telink
samples provided to customers are already paired, so the pairing steps in this section
can be skipped.
Before pairing operation, both the RC and Dongle should be burned with the
right firmware, respectively. Telink-supplied RC and Dongle samples are preloaded
with FW already. If user needs to update the FW, please follow the operations as
described in the document “AN_FBD-EVK-UG_Firmware burning and debugging
User Guide” or implement OTA upgrade (see section 9).
The RC demo supports pairing and un-pairing initiated by the demo dongle side.
4.1 Pairing between RC and dongle
The pairing operation is as shown below:
1) Power on the BLE RC. Insert the BLE Dongle into PC.
2) Click the “SW1” button of the BLE Dongle to start pairing process.
3) The red LED light on the BLE Dongle will be turned on and keep the state always
to indicate successful pairing.