PW24 2.
TABLE OF CONTENTS 1. 2. 3. 4. 5. 6. 7. Quick Set Up and Operation ....................................................... 3 Installation.................................................................................... 4 Guidelines For Best Performance................................................ 5 Troubleshooting Guide................................................................. 6 Technical Specifications .............................................................. 7 Service and Warranty ......
QUICK SET UP AND OPERATION Synching Up The Transmitter and Base 1) Turn the transmitter power switch to on and place the transmitter in the recharge cradle of the base. The transmitter goes in the base with the beltclip facing out. 2) The recharge LED will light (Green if fully charged, Red if charging) and the In-Use Green LED on the base and transmitter will flash 3 times.
INSTALLATION 1. Wire the un-terminated signal wires to the control unit according to the signal chart. A 5 Amp fast blow fuse is recommend in the 12VDC power supply line to protect the equipment. Audio In Un-terminated wires 12 FT Description Power +12V DC Microphone Trigger (Ground = Transmitter On) Left Channel (Ground to enable Inside Microphone) Power Ground AUX (Panic) Trigger 12V+ DC Output when EMG button is pushed Color Red Black Yellow Orange White 2. Plug the 3.
4) Guidelines and recommendations for best performance. Compatibility The transmitter and receiver must synchronize to work together by placing the transmitter into the charging cradle while on. The In-Use LEDs will flash three times and the two are synchronized. Any PR24 can be synchronized with any PB24 base. Using Multiple Wireless Systems The PW24 system has 40 possible “channels” that are really different frequency hopping schemes.
5) Trouble Shooting Guide Problem No audio and no In-Use LED light on the receiver when transmitter is on and In-Use Possible Causes Receiver is not powered Solutions Make sure that the power supply is properly connected Transmitter and receiver not synchronized No (or low) Audio with all InUse LEDs solid green Turn on transmitter and place in recharge cradle.
PR24 RECEIVER BASE STATION Indicators INUSE LED: CHARGE LED : Connections In Car Mic Un-terminated Cord RED BLACK WHITE YELLOW ORANGE Audio Connector Tip Ring Sleeve RF Specifications Frequency Range: Number of Channels: Diversity: Receiver Type: RF Sensitivity: FCC type acceptance: Audio Specifications Frequency Response: Audio Output Level: Distortion: Signal to Noise Ratio: Dynamic Range: General Specifications Range Power Supply: Current Draw: Size: Weight GREEN CHARGING -> RED FULL CHARGED -> GREEN 2.
Factory Service (North America) If factory service is required, ship the unit prepaid in its original carton to: Telex Audio Service c/o Telex Communications 8601 East Cornhusker Highway Lincoln, NE 68507-9702 U.S.A. Tel: 402/467-5321 or 800-553-5992 Fax: 402/467-3279 Enclose a note describing the problem along with any other pertinent information and how to contact you.
