CDR-1000 OPERATING INSTRUCTIONS SUPPLEMENT
TABLE OF CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. Quick System Setup . . . . . . . . . . . . . . . . . . . . . . . . . See Section 1 in the main RE-1 Instructions System Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Detailed Component Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Detailed Description of Unique CDR-1000 Features 1. Headset Port. . . . . . . . . .
Section 3 Detailed Component Descriptions CDR-1000 RECEIVER CONTROLS, CONNECTORS AND INDICATORS 2d 2c 1 R 1 2 menu 1 R RE-1 CDR-1000 2b 2a Featuring set power 4 3 2 menu set Figure 1 Front Panel CDR-1000 Receiver PATENT NO. 6,256,484 CDR-1000 DUAL RECEIVER MADE IN U.S.A.
Section 4 Detailed Description of Unique CDR-1000 Features 2. The CDR-1000 is equipped with a left and right antenna output jack. These jacks can be used to connect up to 3 CDR-1000 (6 receivers) to two antennas without any additional equipment. DO NOT remove “dummy” loads unless connecting to another CDR-1000. Headset Operation 1.
RE-OneLink PC Software LPA500 LPA500 R R UHFLOG PERIODIC ANTENNA UHFLOG PERIODIC ANTENNA THIS END TOWARD TRANSMITTER THIS END TOWARD TRANSMITTER 1. Software to monitor and control the CDR-1000 receivers from a PC through the USB port is available at www.electrovoice.com.
Section 5 Trouble Shooting Guide Problem Possible Causes Solutions Receiver audio output cable is Repair, replace cable or connect No (or low) Audio with good RF disconnected or connected to cable to the correct receiver. signal and Audio indicatiors on the wrong receiver. receiver display Audio Output in Mic position or Adjust audio output (See Audio line level adjustment low Low RF Signal Output section) antennas connected to output Connect antennas to the input instead of input jack. jack.
Section 7 Certification CERTIFICATIONS (Depending on frequency selected and country of operation) CDR-1000 Receiver, CSH-1000 Transmitter, CSB-1000 Transmitter Certified to ETSI EN 300 422-2 and ETSI EN 301 489-3, Conforms to European Union directives, eligible to bear CE marking as per the R&TTE Directive. Certified for use in Canada under RSS 123 Issue 1. The CDR-1000 is authorized under United States Federal Communications Commission, Part 15.
TELEX COMMUNICATIONS, INC. • 12000 Portland Ave. South, Burnsville, MN 55337. PN AUG 2002 Made in U.S.A.
