User guide

2 223 Series Adaptor panels to Motorola MCS Mobile
3.3 IP223 Setup:
Setup the desired IP223 lines jumpers for Local radio control.
3.3.1 IP223 Jumper settings:
Line 1 Jumper setting Line 2
J33, J34
“B”=4-wire
J5, J6
J16, J21
“A”=Single Ended
J19, J20
J14
“Hanging on center pin”= 10K Ohm
J24
J3, J9, J11
“A”=Single Ended
J25, J28, J29
J13
“B” High
J27
J17, J22
“B”= 600 ohms
J10, J15
R377
Solder bridge the pads together
R381
Suggestions or Comments
We’d appreciate your input. Please send us your suggestions or comments concerning this application
note, by fax [phone]) or e-mail them to
: [e-mail]
Technical Support:
Email address: [e-mail]
Phone #: [phone]
TELEX Communications, Inc.
Vega Signaling Products
8601 East Cornhusker Highway, Lincoln, Nebraska, 68507
Phone: [phone] Fax: [phone]
E-mail: [e-mail], Web: www.vega-signaling.com