User guide

ManualsBrandsTelex ManualsRadio StationsMCS2000

Application Guide

Motorola

MCS2000 radios to

223 Series Adaptor Panels

June 7, 2006 P/N AN-VEGA-20 Rev A

Summary of content (4 pages)

PAGE 1
Application Guide Motorola MCS2000 radios to 223 Series Adaptor Panels June 7, 2006 P/N AN-VEGA-20 Rev A
PAGE 2
II 223 Series Adaptor panels to Motorola MCS Mobile Table of Contents 1 General ................................................................................... 1 2 Interconnect Cable assembly ............................................... 1 3 223 Series panels: ................................................................. 1 3.1 TRA223 Setup: ............................................................................................................... 1 3.1.1 TRA223 Dip-Switch settings:..........
PAGE 3
223 Series Adaptor panels to Motorola MCS Mobile 1 1 General This application note is intended to show how to assemble a cable and setup the hardware of different 223 series adaptor panels (TRA223, DSP223 and IP223) to a Motorola MCS20000 series mobile radio. 2 Interconnect Cable assembly A cable assembly will be required to connect to the 26-pin accessory connector of the XTL to the various 223 Series adaptor panels. Please use the following chart to manufacture this cable assy.
PAGE 4
223 Series Adaptor panels to Motorola MCS Mobile 2 3.3 IP223 Setup: Setup the desired IP223 lines jumpers for Local radio control. 3.3.1 IP223 Jumper settings: Line 1 J33, J34 J16, J21 J14 J3, J9, J11 J13 J17, J22 R377 Jumper setting “B”=4-wire “A”=Single Ended “Hanging on center pin”= 10K Ohm “A”=Single Ended “B” High “B”= 600 ohms Solder bridge the pads together Line 2 J5, J6 J19, J20 J24 J25, J28, J29 J27 J10, J15 R381 Suggestions or Comments We’d appreciate your input.