CDR-1000 OPERATING INSTRUCTIONS SUPPLEMENT
TABLE OF CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. Quick System Setup . . . . . . . . . . . . . . . . . . . . . . . . . See Section 1 in the main RE-1 Instructions System Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Detailed Component Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Detailed Description of Unique CDR-1000 Features 1. Headset Port. . . . . . . . . .
Section 3 Detailed Component Descriptions CDR-1000 RECEIVER CONTROLS, CONNECTORS AND INDICATORS 2d 2c 1 R 1 menu menu 2 R 1 2 RE-1 CDR-1000 Featuring set set power 2b 2a 4 3 4 3 4 Figure 1 Front Panel CDR-1000 Receiver POWER PATENT NO. 6,256,484 90-260 VAC 50-60 Hz CDR-1000 DUAL RECEIVER MADE IN U.S.A.
Section 4 Detailed Description of Unique CDR-1000 Features Headphone Operation LPA500 R LPA500 UHFLOG PERIODIC ANTENNA R THIS END TOWARD TRANSMITTER UHFLOG PERIODIC ANTENNA THIS END TOWARD TRANSMITTER 1. With the transmitters and receivers setup and operating (see Sections 1 and 3 in the main RE-1 Operating Instructions), plug stereo headphones into the 1/4inch jack on the front panel. PATENT NO. 6,256,484 90-260 VAC 50-60 Hz CDR-1000 DUAL RECEIVER MADE IN U.S.A.
RE-OneLink PC Software LPA500 LPA500 R UHFLOG PERIODIC ANTENNA R UHFLOG PERIODIC ANTENNA 1. Software to monitor and control the CDR-1000 receivers from a PC through the USB port is available at www.electrovoice.com.
Section 5 Trouble Shooting Guide Problem No (or low) Audio with good RF signal and Audio indicatiors on receiver display Low RF Signal Possible Causes Solutions Receiver audio output cable is disconnected or connected to the wrong receiver. Repair, replace cable or connect cable to the correct receiver. Audio Output in Mic position or line level adjustment low Adjust audio output (See Audio Output section) antennas connected to output instead of input jack. Connect antennas to the input jack.
Section 7 Certification CERTIFICATIONS (Depending on frequency selected and country of operation) CDR-1000 Receiver, CSH-1000 Transmitter, CSB-1000 Transmitter Certified to ETSI EN 300 422-2 and ETSI EN 301 489-3, Conforms to European Union directives, eligible to bear CE marking as per the R&TTE Directive. Certified for use in Canada under RSS 123 Issue 1. The CDR-1000 is authorized under United States Federal Communications Commission, Part 15.
TELEX COMMUNICATIONS, INC. • 12000 Portland Ave. South, Burnsville, MN 55337. PN 803554 Rev. D JAN 2003 Made in U.S.A.
