Intercom Systems Operating Instructions
Table Of Contents
- Operating Instructions
- BP-1002/BP-2002 Beltpacks Audicom Intercom Systems
- System Power
- Initial BP-1002/2002 Setup
- Operating Modes
- Changing Modes of Operation
- 9. Press and hold the Talk key, and then press and hold the Call key.
- 10. Release both keys. The Call indicator should now glow red. (The number of beeps heard in the headset indicates the current mode of operation.)
- 11. Press the Call key to change to the next mode of operation. Each press of the Call key will cause the BP-1002/2002 to change to the next mode of operation.
- 12. When the desired mode is reached, press the Talk key to select that mode and exit the mode changing function. Beeps will be ...
- TABLE 1. Modes of Operation
- Changing Modes of Operation
- Internal Switches, Jumpers and Adjustments
- Connector Pin Configurations
- Specifications
- Optional Football Modifications
- Notes
Introduction 1
CHAPTER 1
Introduction
WARNING: If you have a BP-1002/2002 with a 9030-7740-XXX circuit board,
you will need to obtain Revision H of this user manual.
The Audiocom
®1
BP-1002 and BP-2002 are microprocessor controlled one- and
two-channel intercom beltpacks. An internal switch and jumper setting allows the
units to be used with Clear-Com
®2
components, if desired. Other internal switch and
jumper settings allow the unit to be uniquely configured to the operator’s
requirements.
1. Audiocom
®
is a registered trademark of Telex Communications, Inc., Burnsville, MN
55337.
2. Clear-Com
®
is a registered trademark of Clear-Com Intercom Systems.