Intercom Systems Operating Instructions
Table Of Contents
- Operating Instructions
- BP-1002/BP-2002 Beltpacks Audicom Intercom Systems
- System Power
- Initial BP-1002/2002 Setup
- Operating Modes
- Changing Modes of Operation
- 9. Press and hold the Talk key, and then press and hold the Call key.
- 10. Release both keys. The Call indicator should now glow red. (The number of beeps heard in the headset indicates the current mode of operation.)
- 11. Press the Call key to change to the next mode of operation. Each press of the Call key will cause the BP-1002/2002 to change to the next mode of operation.
- 12. When the desired mode is reached, press the Talk key to select that mode and exit the mode changing function. Beeps will be ...
- TABLE 1. Modes of Operation
- Changing Modes of Operation
- Internal Switches, Jumpers and Adjustments
- Connector Pin Configurations
- Specifications
- Optional Football Modifications
- Notes
8 Operation
To adjust mic gain, do the following:
> Using a Phillips head screw driver, turn the Mic Gain pot clockwise to
increase the gain (or counter-clockwise to decrease the gain).
Clear-Com Setup
Make the following switch and jumper changes when the beltpack is used with
Clear-Com equipment.
BP-1002/2002
> SW1 must be placed in the UNBAL position.
TABLE 2. Internal Switches and Jumpers
Jumper/
Switch
Number
Jumper or Switch Function
Default
Setting
JP1 and JP2
Power Select
Pins 2 & 3 are
shorted
Channel One Power: pins 2 & 3 shorted
(On BP-1002, pins 2 & 3 are always shorted
Channel Two Power: pins 1 & 2 are shorted
SW1
Clear-Com/Audiocom
®
BAL
Unbalanced/Balanced Line
JP3
Must be left on default
Pins 2 & 3
shorted
JP5
Pins 1 & 2 Shorted
Pins 1 & 2
shorted