Operation Manual
Hardware Setup
7
N750 Wireless Dual Band Gigabit Access Point WNDR4300-TN
The following table describes the LEDs, icons, and buttons on the front panel from left to
right.
Item Description
Power
• Solid amber. The access point is starting after being powered on.
• Solid green.
The access point is ready to use.
• Off.
The access point does not have power.
• Blinking green. The
firmware is corrupted.
• Blinking amber.
The firmware is upgrading, or someone pressed the Restore
Factory Settings button.
2.4 GHz
• Solid green. The access point has 2.4 GHz wireless radio connectivity.
• Off. The
2.4 GHz wireless radio is off.
5 GHz
• Solid blue. The access point has 5 GHz wireless radio connectivity.
• Off. The
5 GHz wireless radio is off.
LAN 1 - 4
• Solid green. The LAN port detected a 1 Gbps link with an attached device.
• Solid amber.
The LAN port detected a 10/100 Mbps link with an attached device.
• Off.
The gateway does not detect a link on this port.
Wireless
button
Pressing this button for more than one second turns the wireless radios on and off .
• On. The
2.4 GHz and 5 GHz wireless radios are on.
• Off.
The 2.4 GHz and 5 GHz wireless radios are off, and the 2.4 GHz and 5 GHz
LEDs are off.
WPS button Pressing this button allows you to use Wi-Fi Protected Setup (WPS) to add a wireless
device or computer to your network (see Wi-Fi Protected Setup (WPS) Method on
page 12). The WPS LED blinks for two minutes during this process.
Back Panel
The back panel has the On/Off button and port connections as shown in the figure.
Ethernet PowerPower
LAN ports connetor on/of
Figure 2. Back panel