User Manual

SWITCH SETTINGS
Message Waiting Switch
There are two (2) slide sw
itches located on the
base unit under a plastic cover. Use a sharp pointer to remove
the switch plastic cover plate to expose the two switches.
These switches control how the message-waiting
lamp (MWL) works:
Position: Mode:
TYPE Responds to “high-voltage” (neon type) MWL
signaling, and also to “low
-voltage”
(LED type) MWL signaling
LR1 Reverse polarity MWL, polarity 1
LR2 Reverse polarity MWL, polarity 2
The second switch (On/Off) enables the MWL when
switched on, but completely disco
nnects the MWL circuit
when switched off.
The default Message Waiting switch settings should be:
 Message Waiting ON/OFF switch needs to be set to “ON”.
 Message Waiting TYPE/LR1/LR2 switch needs to be set
to “TYPE”.
14