Manual
Installation...
Caution Information -
•
Never install telephone or network wiring during a lightning storm.
• Never install telephone or Ethernet jacks in wet locations unless the jack is specically
designed for wet locations.
• Never touch uninstalled telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
• Use caution when installing or modifying telephone and network lines.
Connecting the Handset Cord - # 20a & 20b
A 9 ft. modular handset coil cord is provided. To install, simply plug one end of the coil
cord into the jack at the base of the handset, and the other end into the jack located on
the left side of the telephone base marked “Handset”.
Connecting the Line Cord - # 8
A 15 ft. modular line cord is provided. To install, simply plug one end of the cord into the
modular jack at the top end of the base unit and the other end into the wall jack.
TABLE of CONTENTS:
Features
Features & Controls page 1
Features & Controls pgs 13/14
Parts List page 2
Compliance/Safety page 2
Installation
Caution Information page 3
Connecting Handset & Line Cord page 3
PassPort™ pass-through HSIA page 3
Switch Settings page 4
message waiting/line voltage
Wall Mounting page 10
Operation
Handset & Speaker Volume page 4
Ringer Volume page 4
LED Indicators page 5
Mute Key page 5
Conference/Flash (Recall) Key page 5
Calling page 6
Speakerphone Key page 6
Programming
Speed Dial Memory Keys page 7
Flash & Pause Timing page 7
Flash & Pause Memory Keys page 8
Message Waiting (TouchLite) page 9
Servicing
Care & Maintenance page 11
Service page 11
PARTS CHECK LIST:
The following parts are included in this pack-
age:
A. Line cord - 15 ft./4.5m.
B. Handset coiled cord - 9 ft./2.5m.
C. Base unit.
D. Handset
E. Printed Faceplate
F. Protective plastic faceplate
overlay
The following are optional Items possibly
included: (Must be ordered separately)
G. Wall Mount Wedge & Short 6
inch to wall line cord.
Please contact TeleMatrix
PriorityCare to order -
prioritycare@telematrix.net
1
Connecting to PassPort™ - # 9a & 9b
The phone is equipped with PassPort™, a High Speed Internet Access port on the right
side of the base unit. This receptacle acts as a pass-through so that the guest may
conntect their laptop into the hotel’s high speed internet system for maximum effeciency.
To connect - place the Ethernet cable from the wall into the RJ45 receptacle at the top
end of the base # 8. (Does not apply to 3300LBY)
COMPLIANCE & SAFETY:
As specied by FCC regulation, we are required to inform you of specic governmental and compliance regulatory
requirements, safety notices, safety instructions and other informative information. TeleMatrix, Inc.. provides this
information in a separate manual. We place the separate Compliance and Safety Manual within each outer box or
product box when shipped.
Prior to reading this operation manual and prior to setting up your telephone, please refer to the Compliance and
Safety Manual.
If the Compliance and Safety Manual is not immediately available. Please obtain a free copy by contacting our
PriorityCare department (prioritycare@telematrix.net) or by downloading a copy on our Internet web site
(www.telematrix.net).
MARQUIS
3300 Series
Telephones
INSTALLATION
& USERS GUIDE