User's Manual

FP300RA User Manual
2140-72018-00-0A REV: A Page 38 Of 38
B-7.4 Transmitter
Enables selecting the Tx antenna and the transmitter output power:
• In the normal mode, the selected setting will take effect when the FP-300RA will
switch to this antenna.
• In the calibration mode, the FP-300RA will switch to the selected antenna and the
selected output power will be adjusted to the new value on next frame.
B-7.5 Receiver
Enables selecting the Rx antenna and the receiver digital squelch:
• In the normal mode, the selected setting will take effect when the FP-300RA will
switch to this antenna.
• In the calibration mode, the FP-300RA will switch to the selected antenna and the
selected digital squelch will be adjusted to the new value on next frame.
B-7.6 Vector Modulator
The vector modulator is configured by the manufacturer and must not be changed unless
explicitly instructed to do so by an authorized Telematics Wireless representative.
B-7.7 Calibration Process
The calibration process section of the RF setting window is open when calibration Tx mode is
selected. The calibration procedure is explained in Appendix E