User's Manual

FP300RA User Manual
2140-72018-00-0A REV: A Page 37 Of 38
B-7. RF Setting Window
Figure B-6 shows a typical RF Setting window.
Figure B-6: Typical RF Setting Window
B-7.1 Get Button
Its function it to get the current RF parameters. When using the CW or modulated mode, the
actual transmit output power is measured and reported.
B-7.2 Set Default Button
Its function is to set the current RF parameters as the FP-300RA default RF parameters.
B-7.3 Tx Mode
Selects the transmitter operating mode:
Normal
The TDMA air interface is active according to the current configuration.
Mute
The TDMA air interface is inactive (no transmission, no reception).
CW
The FP-300RA continuously transmits a CW signal.
Modulated Tx
The FP-300RA continuously transmits a modulated signal.
Calibration
The TDMA air interface is active; the transmission is made via the antenna
selected with Tx Antenna and the reception is made via the antenna selected
with Rx Antenna.
BER Test
mode
Used for FP-300RA receiver testing